PRODUCTS OF THIS APPLICATION:

JGB M8

JGB MG

Blasting with Glass Beads under pressure with Blasting Equipment maintains close control over all foreign matters down to the base metal without dimensional change, without contamination and without overstressing. It produces a consistent metallurgical clean surface finish. Conventional Blasting Materials such as Aluminium Oxide, Sand, Steel Shots will either leave a Chemical Film on the blasted surface or have cutting action. Shot Blasting with the Glass Beads completely prepares metal surface for any type of coating on it such as painting, plating enameling or glass lining.

There are two methods for Shot Blasting. Namely :
• WET SHOT BLASTING.
• DRY BLASTING.

Other purposes of the products are as follows:
1. Clear diverse moulds of impact forging, forging, glass, rubber and plastic, metal casting and extrusion.
2. Eliminate tensile stress, increase fatigue life and enhance stress corrosion resistance. For example, aircraft engine turbo, vane, shaft, undercarriage, diversified springs and gears, etc.
3. Clean and remove slitter edge and burr on the circuit plate and plastic-sealed geminate transistors before stannum soldering
4. Remove stems in the piston and cylinder and provide bright and half-lackluster surface for medical mechanical instruments and automobile parts